Skip to main content

Powering Your CloudBox with PoE

How to power your CloudBox using PoE with a 5V 2A splitter and 5.5mm x 2.1mm plug. Includes recommended tested adapters

Dustin avatar
Written by Dustin
Updated over a week ago

Can I Power My CloudBox Using PoE?

Yes! While the CloudBox doesn’t support Power over Ethernet (PoE) directly, you can use a PoE splitter to safely power it using your existing network infrastructure.

This setup is ideal for clean installations — like equipment racks, server rooms, or ceilings — especially when you want to use power that’s already coming from a central, backup-protected switch or UPS.

What Is PoE?

Power over Ethernet (PoE) allows a single Ethernet cable to carry both data and power. It’s commonly used for devices like IP cameras, phones, and wireless access points. If your network switch supports PoE (or you’re using a PoE injector), you can also use that same power source for your CloudBox — with the help of a small adapter.

How It Works with the CloudBox

The CloudBox uses a 5V 2A DC power supply with a 5.5mm x 2.1mm barrel connector. To use PoE, you’ll need a PoE splitter that:

  • Accepts 48V PoE input (standard IEEE 802.3af)

  • Outputs 5V at 2A

  • Has a 5.5mm x 2.1mm barrel plug that matches the CloudBox power input

Once connected, the PoE splitter draws power from your PoE-enabled switch or injector and converts it to the correct voltage and connector for your CloudBox.

Recommended PoE Adapters

These splitters have been tested with CloudBox devices and are known to work well:

    • Converts 48V PoE to 5V 2.4A

    • Comes with a 5.5mm x 2.1mm barrel plug

    • Simple plug-and-play design

    • Also converts 48V to 5V at 2.4A

    • Outputs to a USB Type-A female port

      • Note: The CloudBox can also be powered through its USB port, but using this splitter requires a USB Type-A male to male cable to connect the splitter’s USB output to the CloudBox.

    • Use this if your switch does not support PoE

    • Adds PoE power to Ethernet lines

    • Still requires one of the splitters above at the CloudBox end

Power Requirements

Requirement

Details

Voltage

5V

Amperage

2A

Connector Type

5.5mm outer / 2.1mm inner barrel plug

PoE Standard

IEEE 802.3af (48V input to splitter)

Need Help?

Not sure which adapter is best for your setup? Our support team is happy to help you pick the right PoE solution for your CloudBox installation.

Did this answer your question?